Skip to content
Toolspire

Device Tests

Touch Screen Test

Touch Screen Test is part of Toolspire and is ready as soon as this page loads. Put a finger on each corner and the centre. Every contact shows as a dot, two fingers report a pinch distance, and the highest number of simultaneous touches is kept.

Runs in this tabFreeNo account

On this page

What you can do here

Live fingers

Each contact is a dot that follows your finger, including a second and a third.

Corner targets

Dead zones often sit in the corners. The four circles plus the centre make those zones obvious.

Pinch distance

Two fingers report how far apart they are, which is the raw input a pinch gesture uses.

A running maximum

Lift and press again with more fingers. The “at once” number stays at the highest count.

The sequence

How to test a touch screen

  1. 1

    Open the page on the device

    A phone or tablet is the real test. A computer can still click the targets with a mouse.

  2. 2

    Hit the five circles

    Touch each corner and the centre. A circle that never turns solid is a dead zone.

  3. 3

    Put two fingers down

    You should see two dots and a pinch distance. Add fingers until the count stops rising — that is the screen’s limit.

  4. 4

    Drag along an edge

    A dot that jumps or vanishes as you slide is a scratch or a failing digitizer.

Worth knowing

  • Touch Screen Test on Toolspire: draws a dot for every finger the browser reports, and shows how many are down at once.
  • Five targets — four corners and the centre — turn solid when a touch lands on them.
  • With two fingers down, the page shows the distance between them in pixels.
  • Remembers the most fingers at once, so you can see whether the screen’s multi-touch limit is 2, 5 or 10.
  • Touch points stay in the tab. They are not stored and not uploaded. A mouse can click the targets on a computer.

A spot the finger cannot hit

  • A screen protector — a lifted corner or a thick glass edge creates a dead band. Peel it back and try the same spot.
  • A case — some cases cover the extreme edge. Take the case off before deciding the panel is faulty.
  • Water or oil — dry the glass. A wet patch can spawn extra touches or swallow a real one.
  • The browser — in-app browsers sometimes mishandle multi-touch. Open the page in Safari or Chrome and try again.

How many touches should a phone report?

Most phones sold in the last decade report at least five simultaneous touches, and many report ten. Two is enough for a pinch. If a modern phone never goes past one finger here, and it also fails in the Maps app, the digitizer — not the site — is the limit.

FAQ

Questions about Touch Screen Test

Where does Touch Screen Test run?

Touch Screen Test runs in this tab on Toolspire. What you type or drop in is not sent to us and is not stored on a server.

How do I test multi-touch?

Put two fingers on the stage at the same time. You should see two dots, a finger count of 2, and a pinch distance. Add fingers until the “at once” number stops increasing.

Why do the corners matter?

A failing touch layer often dies at the edges first. The four corner targets are there so a dead edge is obvious, not just a miss in the middle.

Can I use this on a laptop touchpad?

A touchpad is a pointing device, so it moves one pointer. It will not show ten fingers. Use a phone or tablet screen for the multi-touch count.

The page scrolls instead of drawing a dot.

The stage is set not to scroll while you touch it. If the whole page still moves, you are touching outside the box. Stay inside the bordered area.

Are touches uploaded?

No. Finger positions exist only while the page is open. Reset clears the targets, and closing the tab clears everything.

Keep going

Open the full directory

Last updated Report a problem or suggest a feature